After few iteration, this variable became the same as dts. It's not
the min as the name says, but the dts of the current buffer. Simply
remove and place with dts. Also move the debug trace to actually
print the signed version of the running-time dts.
after e000a6f0a4, there is build error in bad plugins
this happens because, GST_CLOCK_STIME_IS_VALID () is being checked for pad_data
but it expects a GstClockTime parameter. Changing the check to 'dts'
https://bugzilla.gnome.org/show_bug.cgi?id=750961
The segment should start at first PTS, and the vairable name lower_pts
state so correctly. Though we where using the first DTS instead. This
could lead to small desynchronization of video stream.
https://bugzilla.gnome.org/show_bug.cgi?id=740575
Use the saved DTS, make it signed and pass that to the stream muxer. This
preserves the running time sign. All usage of -1 as invalid TS are now
replaced with G_MININT64. Negative values will be seen as wrap-around
point, but the delta between PTS and DTS will remain correct. Demuxers
don't care about absolute values, they only cares about deltas.
https://bugzilla.gnome.org/show_bug.cgi?id=740575
There was code to detect backward dts, but the marker min_dts
was never set. Setting it enable this feature that prevents
potential integer overflow when generating TS.
https://bugzilla.gnome.org/show_bug.cgi?id=740575
Wait until at least one keyframe has been parsed before
deciding to switch to passthrough mode, in case the
stream contains SEI messages that supplement the output
caps - for example by providing stereoscopic information
We were off by one byte in the matching
It should be (using 24 bit matching):
* startcode : 0000 0000 0000 0000 1000 00xx
* mask (bin) : 1111 1111 1111 1111 1111 1100
* mask (hex) : f f f f f c
* match : 0 0 0 0 8 0
https://bugzilla.gnome.org/show_bug.cgi?id=750685
In case of the videomark being partially or fully outside,
an error was bein thrown saying, mark width is more than video width.
And when the width, offset properties are set to maximum it resulted in crash.
Instead of throwing error, added logic to detect the mark
in case of partial visibility or dont show the mark when it is outside.
https://bugzilla.gnome.org/show_bug.cgi?id=743908
In case of the videomark being partially or fully outside, an error was being
thrown saying the mark width is more than video width. And when the width,
offset properties are set to maximum it resulted in crash. Instead of throwing
an error, add logic to detect the mark in case of partial visibility or don't
show the mark when it is outside.
https://bugzilla.gnome.org/show_bug.cgi?id=743908
Chinese broadcaster encapsulate AVS video codec into MPEG2-TS. They
use the stream_id 0x42 to identify AVS video streams. It should be noted
that this id is currently within the ISO reserved range, hence it's
utilisation is unofficial.
https://bugzilla.gnome.org/show_bug.cgi?id=727731
Value of res is reset to FALSE in each iteration of the while loop. We want to
conserve TRUE if any pad event succeeded until we arrive to done.
Also, buf is set to the value of *outbuf twice. Removing the first assignment
since the second one is outside of a conditional.
Like SPS/PPS they do contain information which will be needed to
decode the following data (as per definition of the flag)
Also ensures that the series of SPS/PPS/SEI NALU before a keyframe
can be considered as one contiguous header
In the same way we do it for the DELTA_UNIT flag
This allows downstream elements to know whether a given mpeg-ts
packet contains a corresponding HEADER elementary unit
Timestamps should start at the segment start, rather than 0, so
we need to not subtract the first timestamp. This makes the sink
correctly account for running time when switching PMTs where a
stream starts not quite at zero, causing timing offsets that can
become noticeable and causing dropped frames after a few times.
A new program object is created to replace an existing one
in the programs hash table, so its refcount needs to match.
With the default of 0 refcount on creation, the next PAT
change will cause that refcount to be both incremented and
decremented (assuming the new PAT references that stream too),
which will cause the program to be destroyed.
https://bugzilla.gnome.org/show_bug.cgi?id=748412
In the H263 spec, CPFMT is present only if the use of a custom
picture format is signalled in PLUSEPTYPE and UFEP is "001",
so we need to check params->format and only if the value is
6 (custom source format) the CPFMT should be read, otherwise
it's not present and wrong data will be parsed.
When reading the CPFMT, the width and height were not
calculated correctly (wrong bitmask).
https://bugzilla.gnome.org//show_bug.cgi?id=749253
Rather than one of the input pad video info's.
The test checking this was not constraining the output frame size
to ensure that the out of frame stream was not being displayed.
No need to call gst_remove_silence_reset() in gst_remove_silence_init() because
vad_new() already calls this function. Since there are no more uses of
_silence_reset(), we can remove it altogether.
Don't use the apis in codec-utils to extract the profile and level
syntax elements since it is wrong if there are emulation prevention
bytes existing in the byte-stream data.
https://bugzilla.gnome.org/show_bug.cgi?id=747613
It's a waste of resources to map it if it won't be converted
or used at all. Since we moved the frame mapping down, we need
to use the GST_VIDEO_INFO accessor macros now in the code above
that instead of the GST_VIDEO_FRAME accessor macros.
https://bugzilla.gnome.org/show_bug.cgi?id=746147
For each frame, compare the frame boundaries, check if the format contains an
alpha channel, check opacity, and skip the frame if it's going to be completely
overwritten by a higher zorder frame. The check is O(n^2), but that doesn't
matter here because the number of sinkpads is small.
More can be done to avoid needless drawing, but this covers the majority of
cases. See TODOs. Ideally, a reverse painter's algorithm should be used for
optimal drawing, but memcpy during compositing is small compared to the CPU used
for frame conversion on each pad.
https://bugzilla.gnome.org/show_bug.cgi?id=746147
Don't use the apis in codec-utils to extract the profile,tier and level
syntax elements since it is wrong if there are emulation prevention
bytes existing in the byte-stream data.
https://bugzilla.gnome.org/show_bug.cgi?id=747613
Free the existing descriptor array, if any, before replacing it.
Fix leaks with the
validate.file.playback.scrub_forward_seeking.test-mpeg2-mp3_mxf scenario.
https://bugzilla.gnome.org/show_bug.cgi?id=748580
If the stream which is about to be removed still has a ref on a tag list we
should drop it.
Fix a leak which was occasionally happening with the
validate.file.playback.change_state_intensive.tron_en_ge_aac_h264_ts scenario.
https://bugzilla.gnome.org/show_bug.cgi?id=748576
Replace videocrop ! videoscale ! capsfilter with the digitalzoom
bin that has the same pipeline internally and already updates
the capsfilter automatically when caps change, removing this code
from wrappercamerabinsrc and making it cleaner.
Avoids one extra uneeded renegotiation if the elements are already
configured to their final property values when the caps event
goes through.
Also avoids hitting bug https://bugzilla.gnome.org/show_bug.cgi?id=748344
It contains videocrop ! videoscale ! capsfilter and implements digital
zooming.
At this moment, it is a private element of the camerabin plugin.
This will remove some code used in wrappercamerabinsrc to make
code clearer and digitalzoom can potentially be used by other
applications in the future, it has nothing camerabin specific.
wrappercamerabinsrc has a videocrop element to be used for
zooming and for cropping when input caps is different when used
with the GstPhotography interface. The zooming part needs
the following elements:
capsfilter ! videocrop ! videoscale ! capsfilter
The capsfilters should always have the same caps to ensure the
zooming is done and preserves dimensions, unless when it is needed
to do more cropping due to input dimensions those caps
need to be modified accordingly to preserve the output dimensions.
This, however, makes it hard to get caps negotiation to work properly
as we need to have different caps in the capsfilters to account for
the extra cropping needed. It could be simple for fixed caps but it
gets tricky with unfixed ones.
To solve this, this patch splits the zooming and dimension reduction
cropping into 2 separate videocrop elements. The first one does
the dimension cropping, which is only needed when the GstPhotography
API is used and the source provides a caps that is different than
what is requested, while the second is dedicated to zoom crop only.
The first part of the pipeline goes from:
src ! videoconvert ! capsfilter ! videocrop ! videoscale ! capsfilter
to
src ! videocrop ! videoconvert ! capsfilter ! videocrop ! videoscale ! capsfilter
It might add an extra overhead in the image capture as the image might need
to be cropped twice but this can be solved by enabling videocrop to use
crop metas so only the later one does the real cropping.
It also makes the code a bit simpler.
Remove tee and output-selector and just link the source
pad to the outputs we want as needed.
The way we need to prioritize caps negotiation and allocation
queries depending on the mode enabled is too custom to be
handled using tee and output-selector.
This provides more flexibility and doesn't get in the way of proper
handling of negotiation and allocation queries.
The detection for missing format/alignment is done way before this
codepath is reached (at which point we have already decided of a
format and alignment).
CID #1232800
When block width property is set to 0, exception occurs.
This happens due to divide by zero errors in calculations.
block width property can never be 0. Hence adjusting the minimum value to 1.
https://bugzilla.gnome.org/show_bug.cgi?id=744188
