rename gst-launch --> gst-launch-1.0
replace old elements with new elements(ffmpegcolorspace -> videoconvert, ffenc_** -> avenc_**)
fix caps in examples
https://bugzilla.gnome.org/show_bug.cgi?id=759432
This is to support byte-stream decoder that does not remember the
PPS/SPS after a flush. This is not needed by all decoders, but is
harmless for those that do remember.
https://bugzilla.gnome.org/show_bug.cgi?id=758405
As it's recursive, gst_pad_get_allowed_caps() may also return
empty for anything incompatible downstream. EMPTY is not valid caps
value for gst_caps_fixate(). This lead to assertion and then crash.
Ideally, the negotiate function should be re-factored to have a return
value, and we could make the negotiation fails earlier.
https://bugzilla.gnome.org/show_bug.cgi?id=754122
The SPS struct might be filled out by a call to
gst_h264_parser_parse_subset_sps, which fills out
dynamically allocated data and requires a call
to gst_h264_sps_clear() to free it. Also make sure
to clear out any allocated SPS data when returning
an error.
https://bugzilla.gnome.org/show_bug.cgi?id=753306
Some video bitstreams report a too restrictive set of profiles. If a video
decoder was to strictly follow the indicated profile, it wouldn't support that
stream, whereas it could in theory and in practice. So we should relax the
profile restriction for allowing the decoder to get connected with parser.
https://bugzilla.gnome.org/show_bug.cgi?id=747613
VPS is not mandatory, and need not check for its presence before setting
the caps. Because of the check, in streams which don't have VPS,
sticky event mishandling happens.
https://bugzilla.gnome.org/show_bug.cgi?id=752807
Don't throw away AU delimiter(s) that precede the SPS/PPS. Should
fix MPEG-TS playback on iOS/Quicktime when muxing streams that
already have AU delimiters.
See https://bugzilla.gnome.org/show_bug.cgi?id=736213 for getting
h264parse to insert AU delimiters when they don't already
exist.
Move the pixel-aspect-ratio calculations higher up in caps
determination, so the results are available for a call to
gst_video_multiview_guess_half_aspect() when stereoscopic video
is detected.
Wait until at least one keyframe has been parsed before
deciding to switch to passthrough mode, in case the
stream contains SEI messages that supplement the output
caps - for example by providing stereoscopic information
We were off by one byte in the matching
It should be (using 24 bit matching):
* startcode : 0000 0000 0000 0000 1000 00xx
* mask (bin) : 1111 1111 1111 1111 1111 1100
* mask (hex) : f f f f f c
* match : 0 0 0 0 8 0
https://bugzilla.gnome.org/show_bug.cgi?id=750685
Like SPS/PPS they do contain information which will be needed to
decode the following data (as per definition of the flag)
Also ensures that the series of SPS/PPS/SEI NALU before a keyframe
can be considered as one contiguous header
In the H263 spec, CPFMT is present only if the use of a custom
picture format is signalled in PLUSEPTYPE and UFEP is "001",
so we need to check params->format and only if the value is
6 (custom source format) the CPFMT should be read, otherwise
it's not present and wrong data will be parsed.
When reading the CPFMT, the width and height were not
calculated correctly (wrong bitmask).
https://bugzilla.gnome.org//show_bug.cgi?id=749253
Don't use the apis in codec-utils to extract the profile and level
syntax elements since it is wrong if there are emulation prevention
bytes existing in the byte-stream data.
https://bugzilla.gnome.org/show_bug.cgi?id=747613
Don't use the apis in codec-utils to extract the profile,tier and level
syntax elements since it is wrong if there are emulation prevention
bytes existing in the byte-stream data.
https://bugzilla.gnome.org/show_bug.cgi?id=747613
The detection for missing format/alignment is done way before this
codepath is reached (at which point we have already decided of a
format and alignment).
CID #1232800
This prevents it from going into passthrough after receiving 2
byte-stream caps (different ones) as it would keep the have_pps and
have_sps set to true and would just go into passthrough without
updating its caps.
This patch makes it reset its stream information to restart properly
when new caps are received.
https://bugzilla.gnome.org/show_bug.cgi?id=745409
This patch calls gst_h264_parser_parse_subset_sps() when a
SPS subset NAL type is found.
All the bits required for parsing the SPS subset in NALs were
already there, just we need to call them when the this NAL type
is found.
With this parsing, the number of views (minus 1) attribute is
filled, which was a requirement for negotiating the stereo-high
profile.
https://bugzilla.gnome.org/show_bug.cgi?id=743174
Initial support for MVC NAL units. It is only needed to propagate the
complete set of NAL units downstream at this time.
https://bugzilla.gnome.org/show_bug.cgi?id=696135
Signed-off-by: Sreerenj Balachandran <sreerenj.balachandran@intel.com>
Signed-off-by: Gwenole Beauchesne <gwenole.beauchesne@intel.com>
Some video bitstreams report a too restrictive set of profiles. If a video
decoder was to strictly follow the indicated profile, it wouldn't support that
stream, whereas it could in theory and in practice. So we should relax the
profile restriction for allowing the decoder to get connected with parser.
https://bugzilla.gnome.org/show_bug.cgi?id=739992
Everytime a buffer is being provided from baseparse, we are parsing all the data from the beginning.
But since we would have already parsed some of the data in the previous iterations,
it doesnt make much sense to keep parsing the same everytime.
Hence skipping the data which is already read in previous iterations to improve the parsing performance.
https://bugzilla.gnome.org/show_bug.cgi?id=740058
Some video bitstreams report a too restrictive set of profiles. If a video
decoder was to strictly follow the indicated profile, it wouldn't support that
stream, whereas it could in theory and in practice. So we should relax the
profile restriction for allowing the decoder to get connected with parser.
https://bugzilla.gnome.org/show_bug.cgi?id=739992
Read PNG data chunk in one go by letting the parser
base class know the size we need, so that it doesn't
drip-feed us small chunks of data (causing a lot of
reallocs and memcpy in the process) until we have
everything.
Improves parsing performance of very large PNG files
(65MB) from ~13 seconds to a couple of millisecs.
https://bugzilla.gnome.org/show_bug.cgi?id=736176
This commit add an helper to convert a frame to frame-layer format and
use it to implement these two stream-format conversion:
- asf --> sequence-layer-frame-layer
- asf --> frame-layer
In simple/main profile, we basically have a raw frame, so building a
frame layer isn't too complicated. But in advanced profile, the first
frame-layer should contain sequence-header, entrypoint, and frame and
each keyframe should contain entrypoint, so we have to handle these
carefully.
https://bugzilla.gnome.org/show_bug.cgi?id=738526
Add an helper to check that output stream-format is coherent with
profile and header-format. It also check if we know how to do the
conversion if the input stream-format differs from selected
output-format.
So, in case output stream-format is not allowed, it will now fail at
negotiation rather than in pre_push_frame.
https://bugzilla.gnome.org/show_bug.cgi?id=738526
