The codec setup headers are a lot more likely to have correct information,
especially as it's easy to remux a skeleton in a file where streams don't
have the same parameters (I've even seen a file with two skeletons).
Still, this is useful in the case we have a codec we can't decode, so we
can at least (theoretically) convert granpos to time, so we discard this
information if the codec setup has already provided it.
This fixes playback on (at lesat) the original archive.org encoding of
"The Night of the Living Dead" (now replaced by another encoding).
https://bugzilla.gnome.org/show_bug.cgi?id=612443
This could happen when testing with navseek, and pressing
right and left at roughly the same time. The current chain
is temporarily moved away, and this caused the flush events
not to be sent to the source pads, which would cause the
data queues downstream to reject incoming data after the
seek, and shut down, wedging the pipeline.
Now, I can't really decide whether this is a nasty steaming
hack or a good fix, but it certainly does fix the issue, and
does not seem to break anything else so far.
https://bugzilla.gnome.org/show_bug.cgi?id=621897
This patch implements seeking in push mode (eg, over the net)
in Ogg, using the double bisection method.
As a side effect, it also fixes duration determination of network
streams, by seeking to the end to check the actual duration.
Known issues:
- Getting an EOS while seeking stops the streaming task, I can't
find a way to prevent this (eg, by issuing a seek in the event
handler).
- Seeking twice in a VERY short succession with playbin2 fails
for streams with subtitles, we end up pushing in a dataqueue
which is flushing. Rare in normal use AFAICT.
- Seeking is slow on slow links - byte ranges guesses could be
made better, decreasing the number of required requests
- If no granule position is found in the last 64 KB of a stream,
duration will be left unknown (should be pretty rare)
https://bugzilla.gnome.org/show_bug.cgi?id=621897
The first packet of a sparse stream may arrive after an initial
delay in the stream. If ogg_stream_packetout reports a discontinuity
in a sparse stream, do not propagate it to other streams in the
chain unnecessarily.
https://bugzilla.gnome.org/show_bug.cgi?id=621897
After all, we do hope to find actual data for these streams.
However, warn if we could not set up a chain when we find a
non BOS page, as that means we don't have a valid Ogg stream.
https://bugzilla.gnome.org/show_bug.cgi?id=657151
While the casual reader might end up bewildered by just why this
change might increase clarity, it just happens than, in the libogg
and associated sources, op is the canonical name for an ogg_packet
whlie og is the canonical name for an ogg_page, and reading this
code confuses me.
https://bugzilla.gnome.org/show_bug.cgi?id=657151
Headers are inherently durationless.
Instead, set duration to 0 to avoid increasing tracked granpos,
and do not warn about it, since it is totally expected.
https://bugzilla.gnome.org/show_bug.cgi?id=657151
If ints are 64 bits, 32 bits should get promoted in varargs anyway,
and we don't care about 16 bit ints.
This makes the code a lot more readable, and still gets us nice
hexadecimal 32 bit serialnos.
https://bugzilla.gnome.org/show_bug.cgi?id=656775
This was causing keyframe_granule to be set to 0 for all streams
when seeking to the beginning of the stream, i.e., at the
beginning of playback. Fixes#619778.
allocate buffers using gst_buffer_new_and_alloc() instead of
gst_pad_alloc_buffer_and_set_caps(), as the first one will
cause the pad to block, and we don't want that since that will
prevent subsequent pads from being fed if a block occurs at
start, when all pads must be fed for playback to start.
This fixes autoplugging of the tiger element and other things.
https://bugzilla.gnome.org/show_bug.cgi?id=637822
Oggdemux will currently try to pad alloc a buffer from the peer when it is
reading the header files. This is a relic from the time where we had an internal
parser and needs to be removed at some point in time.
The problem is that when there is no peer pad yet (which is normal when
collecting headers) we should still continue to parse all the packets of a
page instead of erroring out on NOT_LINKED.
Fixes#632167
Only keep the last valid granulepos we see when scanning the last
pages. It is possible that the last page that we inspect has a -1 granulepos, in
which case we want to keep the previous valid time instead.
Fixes#631703
Files with a skeleton, or other files with a stream that ends before the end of
the chain would start playing from the end of the chain when trying to seek with
a negative rate at a position between the end of any stream and the end of the
chain.
This is due to the loop in _do_seek() assuming that pages will be encountered
for all streams shortly after the place where we want to seek, as found by
do_binary_search().
In the first iteration of the loop, stream ends are now checked against the
time of the current page.
Convert seek requests to bytes using the bitrate and forward them upstream. Does
not quite work because the flushing and resyncing is not implemented yet.
We update the passed begintime argument to narrow our search region in the
binary search. This means that it does not always contain the chain begin time
after a couple of bisects. Use the real chain->begin_time to bring the
granuletime to the time in the chain instead.
Fixes#610005
This can happen if the combined flow return is not OK although the
allocation succeeded or if the packet in question is a BOS and we're
not going to push headers.
Fixes bug #608699.
Use _ogg_packet_free() instead of gst_mini_object_unref in one more
place now that the header list contains ogg packets and not buffers.
file: Stephen_Fry-Happy_Birthday_GNU-nq_600px_425kbit.ogv
Last stop is already based on the chain start and there is no need
to subtract the chain start as it may lead to a negative overflow.
This was causing seeking issues when the target chain was not
the first one (that has chain start = 0)
Fixes#606382
When performing seeks, the granulepos should be offset by
its chain start time to avoid using wrong values to
update segment's last_stop. A sample file is indicated on
bug #606382
Keep a list of headers for each stream of a chain. When a chain is activated,
push the headers before pushing the data so that decoders can sync.
Fix seeking in chains, take the chain start time into account when comparing
timestamps.
See #606382
Implement keyframe seeking in oggdemux by doing the double seek trick. First
seek to the required position, then read pages for all streams to grab the
granulepos (to know the timing of the keyframe) of each stream, then seek back
to the first keyframe.
After a seek, discard all packets before the packet with the granulepos on it so
that the output buffers contain valid timestamps.
Reorder some code so that we check the timestamps before allocating and pushing
an output buffer.
Do more checks on valid packets in ogm mode.
OGM demuxing no longer requires helper elements. It's done internally
in oggdemux. Vorbis comments are still not handled because I don't
have anything to test with.
gstoggstream.c:419: error: format ‘%lld’ expects type ‘long long int’, but argument 8 has type ‘gint64’
gstoggdemux.c:2253: error: format ‘%lld’ expects type ‘long long int’, but argument 8 has type ‘GstClockTime’
gstoggdemux.c:2333: error: format ‘%lld’ expects type ‘long long int’, but argument 8 has type ‘GstClockTime’
Timestamp generation was broken by the last commit for formats
with a non-zero granule shift. Also keep track of the last keyframe
so that we can regenerate granulepos for theora.
Add a granule to granulepos conversion function. Fix the duration
function for vorbis. Handle timestamps on header packets differently
and be more careful about calculating OFFSET and OFFSET_END. After
this change, timestamps for vorbis don't exactly match up with the
timestamps that vorbisparse outputs, but it's unclear if vorbisparse
is actually correct and it would add a lot more code to make oggdemux
match vorbisparse. Fixes#602790.
Adds code that parses headers of various formats encapsulated in
Ogg in order to calculate timestamps and durations of each buffer.
Removes the creation of helper decoder elements to do this calculation
via conversion queries.
Fixes: #344013, #568014.
For this to work properly, theoradec and vorbisdec need to put
tag events received from upstream into the pending_events list
so they get pushed out after any newsegment event, not before.
When we feed the ogg sync layer, we need to feed it contiguous data even if the
sync layer did not consume all of it yet. This makes sure that it always finds
the next page even for more corrupted files. Use a different read_offset for
this purpose. since we now keep track of the sync layer, we don't have to reset
after finding a start of a page.
Add some more debug info for the error paths.
Only reset the sync layer when we perform a seek operation.
Avoid failure when the next chain has no bos pages but instead simply ignore it.
when we receive unknown page serial numbers mid stream, don't fail but post a
warning and hope that we get back on track later.
Fixes#579642
Original commit message from CVS:
* ext/ogg/gstoggdemux.c: (gst_ogg_pad_class_init),
(gst_ogg_pad_dispose), (gst_ogg_pad_finalize):
Use G_DEFINE_TYPE for the OggPad to get some threadsafe type
init from glib.
Original commit message from CVS:
* ext/ogg/gstoggdemux.c: (gst_ogg_demux_sink_event):
If no stream was found before receiving EOS, post an error message.
Fixes#561924.
Original commit message from CVS:
* ext/ogg/gstoggdemux.c: (gst_ogg_pad_submit_packet),
(gst_ogg_demux_deactivate_current_chain),
(gst_ogg_demux_perform_seek), (gst_ogg_demux_handle_page),
(gst_ogg_demux_loop):
* ext/ogg/gstoggdemux.h:
Copy seqnums around to track playback segments and messages.
Original commit message from CVS:
Patch by: Alessandro Dessina <alessandro nnva org>
* ext/ogg/gstoggdemux.c: (gst_ogg_demux_deactivate_current_chain),
(gst_ogg_demux_activate_chain):
Don't add pads and activate them for skeleton streams. These are already
handled inside oggdemux. Fixes bug #537599.
Original commit message from CVS:
* ext/ogg/gstoggdemux.c: (gst_ogg_demux_chain_peer),
(gst_ogg_demux_perform_seek), (gst_ogg_demux_handle_page):
Don't use GST_CLOCK_TIME_NONE as start of NEWSEGMENT events.
This fixes a critical warning.
Original commit message from CVS:
Patch by: Jan Gerber <j at oil21 dot org>
* ext/ogg/gstoggdemux.c: (gst_ogg_pad_parse_skeleton_fisbone):
Fix calculation of the start time from skeleton streams.
Fixes bug #530068.
