gst_buffer_map () results in memcopying when a GstBuffer contains
more than one GstMemory.
This has quite an impact on performance on systems with limited amount
of resources. With this patch the whole GstBuffer will not be mapped at
once, instead each individual GstMemory will be iterated and mapped
separately.
There is a use-case for a server to re-payload opus going through it.
Problem was that the payloader requires channels in the caps, but
this is not something the depayloader can parse out of the stream, meaning
caps-negotiation would fail.
Removing the requirement of channels in the template-caps fixes this.
gst_buffer_map () results in memcopying when a GstBuffer contains
more than one GstMemory and when AVC (length-prefixed) alignment is used.
This has quite an impact on performance on systems with limited amount of
resources. With this patch the whole GstBuffer will not be mapped at once,
instead each individual GstMemory will be iterated and mapped separately.
Add parsed=true to output caps, as we always output
whole frames, timestamped and all. Means also that
the output can be decoded by avdec_mjpeg wihout
plugging an extra parser (which has no rank).
By passing `NULL` to `g_signal_new` instead of a marshaller, GLib will
actually internally optimize the signal (if the marshaller is available
in GLib itself) by also setting the valist marshaller. This makes the
signal emission a bit more performant than the regular marshalling,
which still needs to box into `GValue` and call libffi in case of a
generic marshaller.
Note that for custom marshallers, one would use
`g_signal_set_va_marshaller()` with the valist marshaller instead.
If VP8 is not encoded with error resilience enabled then any packet loss
causes very bad artefacts when decoding and waiting for the next
keyframe instead improves user experience considerably.
adjust/port from rtph264pay and allow sending the configuration data at
every IDR
The payloader was stripping the configuration data when the
config-interval was set to 0. The code was written in such a way !(a >
0) that it stripped the config when it was set at -1 (send config_data
as soon as possible).
This resulted in some MPEG4 streams where no GOP/VOP-I was detected to
be sent out without configuration.
Add a new property "do-aggregate"* to the H.264 RTP payloader which
enables STAP-A aggregation as per [RFC-6184][1]. With aggregation enabled,
packets are bundled instead of sent immediately, up until the MTU size.
Bundles also end at access unit boundaries or when packets have to be
fragmented.
*: The property-name is kept generic since it might apply more widely,
e.g. STAP-B or MTAP.
[1]: https://tools.ietf.org/html/rfc6184#section-5.7
Closes https://gitlab.freedesktop.org/gstreamer/gst-plugins-good/issues/434
