This is the native format that is in use by the webrtc audio processing
library internally, so this avoids internal {de,}interleaving and
format conversion (S16->F32 and back)
https://bugzilla.gnome.org/show_bug.cgi?id=793605
This patch bumps the required meson to 0.40.1 as gstreamer core just
did, and cleanup some code to use a feature from 0.37 that allow
specifying version range when checking dependency.
https://bugzilla.gnome.org/show_bug.cgi?id=780654
The element now exposes properties to enable and configure
voice activity detection, and posts "voice-activity" messages
when the return value of stream_has_voice () changes.
https://bugzilla.gnome.org/show_bug.cgi?id=779138
In this mode, we let WebRTC Audio Processing figure-out the delay. This
is useful when the latency reported by the stack cannot be trusted. Note
that in this mode, the leaking of echo during packet lost is much worst.
It is recommanded to use PLC (e.g. spanplc, or opus built-in plc).
In this mode, we don't do any synchronization. Instead, we simply process all
the available reverse stream data as it comes.
The previous code would run out of sync if there was packet lost
or clock skews. When that happened, the echo cancellation feature would
completely stop working. As this is crucial for audio calls, this patch
re-implement synchronization completely.
Instead of letting it drift until next discont, we now synchronize
against the record data at every iteration. This way we simply never
let the stream drift for longer then 10ms period. We also shorter the
delay by using the latency up the probe (basically excluding the sink
latency. This is a decent delay to avoid starving in the probe queue.
https://bugzilla.gnome.org/show_bug.cgi?id=768009
When echo cancel is enabled, we now fail the pipeline if there is
not echo probe. For this reason there is no need to check if probe
pointer is set anymore.
The saved timestamp is used to compute the delay of the probe data.
As it's used at the following incoming buffer, it needs to be offset
with the duration of the buffer to represent the end position. Also,
properly initialize the saved timestamp and protect against TIME_NONE.
Until now, we were synchronizing both DSP and Probe adapter by
waiting and clipping the probe adapter data. This increases the CPU
usage, can cause copies if the audio is not 10ms aligned and the worst
is that it prevents the processing from compensating for inaccurate
latency. This is also a step forward toward supporting playback
filters.
This DSP library can be used to enhance voice signal for real time
communication call. In implements multiple filters like noise reduction,
high pass filter, echo cancellation, automatic gain control, etc.
The webrtcdsp element can be used along, or with the help of the
webrtcechoprobe if echo cancellation is enabled. The echo probe should
be placed as close as possible to the audio sink, while the DSP is
generally place close to the audio capture. For local testing, one can
use an echo loop pipeline like the following:
autoaudiosrc ! webrtcdsp ! webrtcechoprobe ! autoaudiosink
This pipeline should produce a single echo rather then repeated echo.
Those elements works if they are placed in the same top level pipeline.
https://bugzilla.gnome.org/show_bug.cgi?id=767800
