Prevents downstream from receiving flushes for a seek only in
upstream. Those seeks are only to start reading from the right
offset when skipping or returning to qt atoms.
https://bugzilla.gnome.org/show_bug.cgi?id=758928
Avoid writing a negative number as a large positive
integer in an edit list when the first_ts is smaller
than the first_dts - which can happen when the first
packet received has a PTS but no DTS.
https://bugzilla.gnome.org/show_bug.cgi?id=759615
Don't increment running time from every buffer. The correct
logic to only increment when running time advances is a
little further down, so delete this left-over line.
Leverage response from gst_rtsp_connection_connect_with_response to
determine if the connection should be retried using authentication. If
so, add the appropriate authentication headers based upon the response
and retry the connection.
https://bugzilla.gnome.org/show_bug.cgi?id=749596
The string could exist but with a wrong format, in that case we still want
to reset the values of client_port_range.min and max like we do if there is
no string.
CID 1139593
We would queue 5 consective packets before considering a reset and a proper
discont here. Instead of expecting the next output packet to have the current
seqnum (i.e. the fifth), expect it to have the first seqnum. Otherwise we're
going to drop all queued up packets.
When working in push-mode, we attempt to push out everything currently
buffered in the adapter.
This has two pitfalls:
* We could stop earlier (the moment we get a non-ok or non-not-linked)
* We return the last combined flow return, which might be completely
different from the previous combined flow return
There might be multiple LOAS config in a row in a full frame. The first
one might be a multi-layer config (which we can't properly parse yet)...
but then followed by a valid (single-layer) one.
The code was previously skipping whole frames (instead of just the LOAS
config we failed to read) resulting in multiple frames (seen up to 6s in
some situation) being dropped before finally getting the configuration.
https://bugzilla.gnome.org/show_bug.cgi?id=758826
auds.blockalign is set once the first caps arrive. If
gst_avi_mux_stop_file() is called before this happens then auds.blockalign
is zero and gst_avi_mux_audsink_set_fields() cause a crash:
[...]
avipad->parent.hdr.rate = avipad->auds.av_bps / avipad->auds.blockalign;
[...]
https://bugzilla.gnome.org/show_bug.cgi?id=758912
It's not enough to have timeout or event based SPS/PPS information sent
in RTP packets. There are some scenarios when key frames may appear
more frequently than once a second, in which case the minimum timeout
for "config-interval" of 1 second for sending SPS/PPS is not sufficient.
It might also be desirable in general to make sure the SPS/PPS is
available with every keyframe (packet loss aside), so receivers can
actually pick up decoding immediately from the first keyframe if
SPS/PPS is not signaled out of band.
This patch adds the possibility to send SPS/PPS with every key frame. This
mode can be enabled by setting "config-interval" property to -1. In this
case the payloader will add SPS and PPS before every key (IDR) frame.
https://bugzilla.gnome.org/show_bug.cgi?id=757892
This way we can use -1 as special value, which is nicer than MAXUINT.
This is backwards compatible even with the GValue API, as shown by
a unit test.
https://bugzilla.gnome.org/show_bug.cgi?id=757892
generate_rtcp can produce empty packets when reduced size RTCP is turned on.
Skip them since it doesn't make sense to push them and they cause errors with
elements that expect RTCP packets to contain data (like srtpenc).
When seeking back to restore the mdat position a flush is pushed
through and it resets downstream segment information. Make sure
that after the flush (that does a soft reset) a segment will
be pushed again
Fixes regressions spotted at
https://ci.gstreamer.net/job/GStreamer-master-validate/2100/
10 FourCCs generated with GST_MAKE_FOURCC() in gstqtmux.c and atoms.c
already exist in fourcc.h. Don't duplicate these and use them directly.
Plus moving 6 to fourcc.h, to centralize them all.
This fixes seeking if the first entries in the samples table are negative. The
binary search would always fail on this as the array would not be sorted if
interpreting the negative numbers as huge positive numbers. This caused us to
always output buffers from the beginning after a seek instead of close to the
seek position.
Also add a case to the comparison function for equality.
Actual code is checking for a NULL terminator and a ';' terminator,
for backward compat, in a chained way that cause all events being rejected.
The proper condition is to reject the events when terminator isn't
in ['\0', ';'] set.
https://bugzilla.gnome.org/show_bug.cgi?id=758151
It would be unusual to have the header segment with an 'edts' atom
indicating gaps at the beginning when handling fragmented streams.
The header usually doesn't contain any timestamping information, this
should come from the playlist/manifest and the segments with media
in those scenarios.
https://bugzilla.gnome.org/show_bug.cgi?id=758171
