A data offset with an offset smaller than the moof length is wrong
in smooth streaming streams. The samples will not be located and
eventually playback will error out. So compensate assuming data
is in mdat following moof.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3840>
When calculating the seek range for a live stream, use the same hold-back logic
as when choosing a starting segment, including low-latency segments if
enabled. Permits seeking closer to the live edge when re-synching or catching
up.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3883>
Add a flag to hlsdemux to enable or disable LL-HLS handling.
When LL-HLS is enabled and an LL-HLS playlist is loaded, use the part-hold-back
threshold to choose a starting segment.
For live streams that aren't LL-HLS, use the provided hold-back attribute, or
fall back to landing 3 segments from the end.
Make the gst_hls_media_playlist_seek() method able to choose a partial segment
within 2 target durations of the end of the playlist when requested.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3883>
The rtpjitterbuffer test drop_messages_interval uses a GstClockTime for
the message drop interval. This property is defined as a guint. On
systems with 64-bit time_t but 32-bit uint, this can cause the
g_object_set function to fail to read the arguments properly.
Fixes: #1656
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3580>
Previously we tried to route an incoming RTCP FB FIR to the correct ssrc
using the "media source" component of the RTCP FB message. However,
according to RFC5104 (section 4.3.1.2) the "media source" SHALL be set
to 0. Instead the ssrc(s) in use are propagated via the FCI data. Now
a specific GstForceKeyUnit event is sent for every ssrc.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3292>
in certain ways.
In the case that a test is provided for, the size of the `fmt ` chunk is
changed from 16 bytes to 18 bytes (bytes 17 - 20 below):
```
$ hexdump -C corruptheadertestsrc.wav
00000000 52 49 46 46 e4 fd 00 00 57 41 56 45 66 6d 74 20 |RIFF....WAVEfmt |
00000010 12 00 00 00 01 00 01 00 80 3e 00 00 00 7d 00 00 |.........>...}..|
00000020 02 00 10 00 64 61 74 61 |....data|
00000028
```
(Note that the original file is much larger. This was the smallest sub-file
I could find that would generate the crash.)
Note that, while the same issue doesn't cause a crash in pull mode, there's a
different issue in that the file is processed successfully as if it was a .wav
file with zero samples.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3173>
Update unit test for some mpd cases that were reporting
timestamps including the period start time, while
dashdemux2 expects that it needs to add the period
start time itself.
Fix the tests to not expect the period start time
to be included.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3025>
Just like for the seconds field, there are no limitations on the hours and
minutes fields. The specification for xml schema duration fields doesn't forbid
specifying durations with only (huge) minutes or hours values.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/2951>
Uses prelude header files with #defines to rename DASH and MSS
symbols duplicated in their old standalone versions.
Also redefines soup-related functions when building it for
adaptivedemux2 to prevent symbol conflicts there.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/2534>
This provides new HLS, DASH and MSS adaptive demuxer elements as a single plugin.
These elements offer many improvements over the legacy elements. They will only
work within a streams-aware context (`urisourcebin`, `uridecodebin3`,
`decodebin3`, `playbin3`, ...).
Stream selection and buffering is handled internally, this allows them to
directly manage the elementary streams and stream selection.
Authors:
* Edward Hervey <edward@centricular.com>
* Jan Schmidt <jan@centricular.com>
* Piotrek Brzeziński <piotr@centricular.com>
* Tim-Philipp Müller <tim@centricular.com>
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/2117>
Two RTP Header extensions are very relevant for rtprtxsend/receive.
1. "urn:ietf:params:rtp-hdrext:sdes:rtp-stream-id": will always be removed
2. "urn:ietf:params:rtp-hdrext:sdes:repaired-rtp-stream-id": will be written
instead of the "rtp-stream-id" header extension.
Currently it's only a simple replacement of one header extension for
another however a future change would only add the relevant extension
based on some heuristics (like, video frames only on one of the rtp key
frame buffers, or only until the rtx ssrc has been validated by the peer)
in order to reduce the required bandwidth.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/1759>
Gapless playback is handled by adjusting buffer timestamps & durations
and by adding GstAudioClippingMeta.
Support for "Frankenstein" streams (= poorly stitched together streams)
is also added, so that gapless playback support doesn't prevent those
from being properly played.
Co-authored-by: Sebastian Dröge <sebastian@centricular.com>
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/1028>
This allows downstream of a payloader to know the RTP header's marker
flag without first having to map the buffer and parse the RTP header.
Especially inside RTP header extension implementations this can be
useful to decide which packet corresponds to e.g. the last packet of a
video frame.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/1776>
In redenc, when input buffers have a header for the TWCC extension,
we now add one to our wrapper buffers.
In ulpfecenc we add one in that case to our protection buffers.
This makes TWCC functional when UlpRed is used in webrtcbin.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/1414>
Follow-up on 97d83056b3, only check
for intersection with the current srccaps when checking if a sinkpad
can accept caps.
I must have been lucky in my firefox testing then, and always entered
the code path with audio getting negotiated first, thus not failing
the is_subset check when srccaps had been negotiated as
application/x-rtp, and an accept-caps query was made for the video
caps with a defined extmap.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/1384>
A previous patch has caused rtpfunnel to output twcc-related
information downstream, however this leaked into upstream
negotiation (through funnel->srccaps), causing payloader to
negotiate twcc caps even when not prompted to do so by the user.
Fix this by only enforcing that upstream sends us application/x-rtp
caps as was the case originally.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/1278>
