Call reset-sync on the rtpbin before we go to playing. This makes us require SR
packets for all streams again before we attempt to sync them. If we don't reset,
it might be that we combine SR packets from before and after the PAUSE/PLAYING
state change and end up with huge bogus offsets.
Don't throw away the first RTCP packet if it arrives before the first
RTP packet but remember and use it to signal sync once we get the
RTP packet.
See https://bugzilla.gnome.org/show_bug.cgi?id=691400
When setting timestamps on outgoing buffers, clear the
dts explicitly, otherwise it may end up being set to a
bogus value from last time it was used. Avoids every
second or so buffer's dts being set to 0. Not that it
should matter for raw video.
When we go to paused, we first flush the connection and then send the pause
command. As a result of the flushing, the scheduled paused command can get
lost. Wait until the connection is completely flushed and the rtsp task is
waiting before issuing the paused or playing request.
Fixes https://bugzilla.gnome.org/show_bug.cgi?id=702705
As cameras tend to have a quite specific set of capabilities (specific
framerates for each resolution), getting the peer caps filtered by our
probed caps can cause a big increase in the caps size which slows down
things quire a bit.
As for negotiation v4l2 iterates through the caps of the peer to find the
first intersection with the probed caps, getting the fully expanded
intersection of capabilities is not useful.
Using the same testcase as for bug #702632, adding this patch on top of
the patches suggested there speeds up getting the inital frame from
around ~14-15 seconds to around ~3-4 seconds.
https://bugzilla.gnome.org/show_bug.cgi?id=702638
This can only reliably work if demuxers have a
separate streaming thread per srcpad. This should be
done in a demuxer base class, which integrates parts
of multiqueue
https://bugzilla.gnome.org/show_bug.cgi?id=701856
bug #700505
Following a representation change that causes a resolution change,
the video decoder fails to decode correctly. Dashdemux detects the
representation change and pushes a new caps event and an
initialization segment (a new moov atom) to the downstream qtdemux,
but it doesn't handle this new moov yet, it will only parse the
first one it receives.
This commit changes qtdemux to accept a new moov in a dash bitstream
switching scenario.
Lock the state of the all our elements and manage their states
outselves. Because we are working async, we can't rely on the state
change function to set the state at the right time or to return the
right return value from the state change function.
Fixes https://bugzilla.gnome.org/show_bug.cgi?id=702046
This reverts commit 01457027e0.
We'll just depend on PulseAudio 2.0 or above instead of having the bug
partially fixed based on the installed libpulse version.
The getcaps function we added uses some pa_format_info_get_prop...
accessor functions that were only added in 2.0, so we only have our
getcaps implementation exist if we're compiling against libpulse 2.0 or
above.
Eventually, we could bump the minimum requirement to 2.0 or above.
https://bugzilla.gnome.org/show_bug.cgi?id=686459
Use special variants for the case when we don't change the panorama (pan=0.0).
Simplify the processing functions by passing the panorama value directy instead
of the instance. Use orc for clearing buffers too.
When the segment start is not 0, this created a situation where
the output_end_time is inferior to output_start_time, and the duration
of the next buffer ended up underflowing.
https://bugzilla.gnome.org/show_bug.cgi?id=701385
