Move processing of the gather list into the flush_parse function.
Add a last ditch attempt to apply timestamps to outgoing buffers
when walking backwards through decoded frames. Requires that each
gathered region has at least one timestamp.
Make sure to remove decoded packets from the decode list when
they are sent - otherwise the list just grows on each cycle, with
more and more frames being decoded and then clipped away.
Break out of the processing loop early on a bad flow return to make
seeking more responsive.
Use the gst_video_decoder_clip_and_push_buf function in reverse
mode, instead of pushing all buffers arbitrarily.
A couple of small efficiency gains in the list handling, by moving
list elements directly and not reallocating, and by reversing
and concatenating the gather list instead of moving it one node
at a time.
Rename the gst_video_decoder_do_finish_frame function to
gst_video_decoder_release_frame.
Rename gst_video_decoder_have_frame_2 to
gst_video_decoder_decode_frame and pass the frame to process
directly, rather than using the current_frame pointer as a holding
pen.
Move the negative rate handling out of the function to where it
is needed, and remove the process flag.
The frames are the owners of the buffers. In cases where a decoder
would keep around reference frames, we need to ensure they don't
disappear early.
To handle this, we pass downstream a complete sub-buffer of the output
buffer, ensuring that the buffer will only be released when downstream
is done with it *AND* the frame is no longer used.
Conflicts:
gst-libs/gst/video/gstvideodecoder.c
A crafted file with invalid pages will cause repeated searches from
earlier offsets in steps of 8500 bytes, but reading till the end of
the stream. Since we know the maximum size of an Ogg page, we can
bound the search for next page, to get a linear behavior (though
still not good enough as it will read the entire file backwards if
there's no valid page till then).
Don't replace the initial frame's timestamp with a bogus
one calculated from the (incorrect for Ogg) frame number just
because the 'sync time' hasn't changed.
Also, don't output a bogus warning about the output_frame being
NULL when it's being dropped/skipped due to QoS.
...and in playbin2 additionally prefer sinks over parsers.
This makes sure that we a) always directly plug a sink if it supports
the (compressed) format and b) always plug parsers in front of decoders.
This avoids that bin being leftover and being found when reusing playbin2,
and fixes restarting on a new URI after failing to activate with a previous
URI.
https://bugzilla.gnome.org/show_bug.cgi?id=673888
For audio/video we should flush too for fastest stream switches but this
currently isn't possible because the flushes would need to go to the sink,
which then causes state changes and causes all timing information to be
changed.
Should work out of the box in 0.11 with the flush-stop that doesn't reset
the times.
Conflicts:
gst/playback/gstplaybin2.c
gst/playback/gstplaysink.c
gst/playback/gstsubtitleoverlay.c
