Allows for "low latency" mpeg-ts mode which is not standard, but somewhat common.
For this to work the sender has to put timestamps at a higher frequency than the spec requires.
PES packets with size 0 are unbounded, and
could therefore overflow the 32-bit size
accumulator.
Add a 32MB limit, which is larger than
any PES packet should ever get. If one does,
then output a 32MB chunk and continue.
A guint32 greater than 2^31 would be interpreted as negative by
gst_util_uint64_scale_int() and critical. Use the 64-bit integer version
of the function instead.
Don't signal a pipeline error when processing incomplete
j2pk PES packets that are too small. That can happen normally
during a DISCONT and shouldn't shut down the whole pipeline
Remove some custom and incomplete seek calculation
logic in favour of gst_segment_do_seek(), and
short-circuit any actual seeking or recalculation
if the position didn't change and just send an updated
segment directly.
This removes the custom seeking logic in favour of
using standard core seek handling.
The default behaviour of rtponviftimestamp is to drop buffers
outside the segment. This creates obvious problems for reverse
playback.
The ONVIF specification unfortunately doesn't describe how to handle
that specific use case, but we can expose a property to let the
user disable the dropping behaviour, and forward these buffers with
a G_MAXUINT64 ONVIF timestamp.
Also modify rtponvifparse to handle such timestamps appropriately.
We reject caps with other framerates as it's impossible to generate
timecodes unless we actually know a constant framerate. Reflect this
also in the pad template caps.
Instead of using a static hardcoded PCR interval, allow the user
to configure it.
Also revert back the default to a 40 ms interval, that was changed
in recent patches for no good reason.
There's no point in working with invalid LTC timestamps as all future
calculations will be wrong based on this, and invalid LTC timestamps can
sometimes be read via the audio input.
This patch just enforces boudaries for the access to the
standard_deviation array (64 floats). Such case can be
seen with a corrupted stream, where there's no hope to
obtain a valid decoded frame anyway.
https://gitlab.freedesktop.org/gstreamer/gst-plugins-bad/issues/1002
The D bit is meant to be set whenever there is a discontinuity
in transmission, and directly maps to the DISCONT flag.
The E bit is not meant to be set on every buffer preceding a
discontinuity, but only on the last buffer of a contiguous section
of recording. This has to be signaled through the unfortunately-named
"discont" field of the custom NtpOffset event.
