The whole not_linked optimisation is really a bit dodgy here, but
let's leave it in place for now and at least start pushing data
again when a pad got linked later, in which case we should get a
RECONFIGURE event.
Current CLAMP checks both if the value is below 0 or above 255. Considering it
is an unsigned value it can never be less than zero, so that comparison is
unnecessary. Switching to using if just for the upper bound.
CID #1139796
Value from left_luminance is assigned to out_luminance here, but that stored
value is not used before it is overwritten in the next cycle of the loop.
Removing assignation.
CID #1226473
As a consequence, tsdemux won't remove its pads anymore on EOS.
Fixes the case when mpegtsbase is not able to process new packets
after EOS as the corresponding pids aren't known anymore because
the programs were removed and the pes/psi were kept, preventing the
PAT to be parsed again.
https://bugzilla.gnome.org/show_bug.cgi?id=738695
It was using a 24000/24000/48000, but I think it meant to use
24000/32000/48000. Not 100% sure...
https://en.wikipedia.org/wiki/G.722.1 has the list of supported
bitrates. It's not clear whether the "flag" code maps to this,
however.
Coverity 206072
This parses the frame_packing_arragement() payload in SEI message.
This information can be used by decoders to appropriately rearrange the
samples which belong to Stereoscopic and Multiview High profiles.
https://bugzilla.gnome.org/show_bug.cgi?id=685215
Signed-off-by: Sreerenj Balachandran <sreerenj.balachandran@intel.com>
Signed-off-by: Gwenole Beauchesne <gwenole.beauchesne@intel.com>
Assume that small backward PCR jumps are just from upstream packet
mis-ordering and don't reset timestamp tracking state - assuming that
things will be OK again shortly.
Make the threshold for detecting discont between sequential buffers
configurable and match the smoothing-latency setting on tsparse
to better cope with data bursts.
When the set-timestamps property is set, use PCRs on the provided
(or autodetected) pcr-pid to apply (or replace) timestamps on the
output buffers, using piece-wise linear interpolation.
This allows tsparse to be used to stream an arbitrary mpeg-ts file,
or to smooth jittery reception timestamps from a network stream.
The reported latency is increased to match the smoothing latency if
necessary.
Otherwise a magic capsfilter after the source is required with
exactly the same caps as the input.
This would've failed before with invalid buffer sizes:
gst-launch-1.0 videotestsrc ! intervideosink intervideosrc ! "video/x-raw,width=640,height=480" ! xvimagesink
Audiomixer blocksize, cant be 0, hence adjusting the minimum value to 1
timeout value of aggregator is defined with MAX of MAXINT64,
but it cannot cross G_MAXLONG * GST_SECOND - 1
Hence changed the max value of the same
https://bugzilla.gnome.org/show_bug.cgi?id=738845
Signal sparse streams properly in stream-start event and force sending
of pending sticky events which have been stored on the pad already and
which otherwise would only be sent on the first buffer or serialized
event (which means very late in case of subtitle streams). Playsink in
playbin waits for stream-start or another serialized event, and if we
don't do this it will wait for the multiqueue to run full before
starting playback, which might take a couple of seconds.
https://bugzilla.gnome.org/show_bug.cgi?id=734040
All pads of a stream are now added at the beginning. In order to cope with
streams that don't get any data (forever or for a long time) we detect gaps
and push out GAP events when needed.
Cleanups and commenting by Jan Schmidt <jan@centricular.com>
https://bugzilla.gnome.org/show_bug.cgi?id=734040
Some VC1 decoder can have different caps according to wmv format, ie
WMV3 or WVC1.
So instead of keeping the first available caps, we interserct with
current WMV format.
https://bugzilla.gnome.org/show_bug.cgi?id=738532
When stream-format is ASF or sequence-layer-raw-frame, we basically have
a raw frame so we can parse it to extract some information such the
keyframe flag. The only requirement is to have a valid sequence-header.
This commit parse the frame header and set the DELTA_UNIT buffer flag in
case the frame is not a keyframe.
https://bugzilla.gnome.org/show_bug.cgi?id=738519
frame-layer header is represented as a sequence of 32 bit unsigned
integer serialized in little-endian byte order, so framesize is on the
first 3 bytes.
SMPTE 421M Annex L.
https://bugzilla.gnome.org/show_bug.cgi?id=738243
Also, strictly speaking, these numbers aren't DLT_*; they are LINKTYPE_* because
libpcap translates from internal OS-specific DLT_ numbering to the portable
LINKTYPE_ number space when writing files.
https://bugzilla.gnome.org/show_bug.cgi?id=738206
GST_BASE_PARSE_FRAME_FLAG_PARSING value is wrong, and the same flag is
not being used presently. Hence changing the value and commenting it out.
This needs to be included in baseparse.h later on
https://bugzilla.gnome.org/show_bug.cgi?id=737411
There are unnecessary definitions for disabling deprecation warnings.
Since GLIB_DISABLE_DEPRECATION_WARNINGS is not needed anymore in these files,
removing the same.
https://bugzilla.gnome.org/show_bug.cgi?id=737559
If a discontinuity in the stream is detected, data is discarded until
a new PES starts. If the first packet after the discontinuity is also
the start of a PES, there is no reason to discard the packets.
https://bugzilla.gnome.org/show_bug.cgi?id=737569
Or not negotiated in the case we would be actually not negotiated
Currently we are getting assertions from
gst_pb_utils_add_codec_description_to_tag_list because of NULL
caps.
https://bugzilla.gnome.org/show_bug.cgi?id=737186
If we don't have a seq_layer_buffer, we also don't have a valid
seq_layer because there are set together in
gst_vc1_parse_handle_seq_layer().
So when output header format is sequence-layer and when we don't have a
seq_layer_buffer, we forge one from seq_hdr.
https://bugzilla.gnome.org/show_bug.cgi?id=736781
Sequence-layer and frame-layer are serialized in little-endian byte
order except for STRUCT_C and framedata fields as described in SMPTE 421M Annex
L.
https://bugzilla.gnome.org/show_bug.cgi?id=736750
packetized mode is being set when framerate is being set
which is not correct. Changing the same by checking the
input segement format. If input segment is in TIME it is
Packetized, and if it is in BYTES it is not.
https://bugzilla.gnome.org/show_bug.cgi?id=736252
This commit fix several issues with sequence layer header forging on
update_caps():
- 0x00000004 unsigned integer is before STRUCT_C.
- Set reserved bits of STRUCT_C to their values for simple/main
profiles in sequence layer header format and ASF header format.
- Sequence layer shall be represented as a sequence of 32 bits unsigned
integers and shall be serialized in little-endian byte order except
for STRUCT_C which shall be serialized in big-endian byte-order.
See SMPTE 421M Annex L for more details about sequence layer format.
https://bugzilla.gnome.org/show_bug.cgi?id=736474
packet_length is defined as a guint16 in the PESHeader structure. This
definition match the specification. But since we add 6 bytes to the
packet_length value (length of start_code + stream_id + packet_length),
we can overflow the guint16 when the value in the PES header is greater
than 65529.
So use a guint32 instead of a guint16 to avoid overflow.
https://bugzilla.gnome.org/show_bug.cgi?id=736490
In gst_data_uri_src_create(), buf cannot be NULL, hence
else if (*buf != NULL) will be invalid so removing the
else if condition and adding a check to unreference buf
in else condition, just in case
https://bugzilla.gnome.org/show_bug.cgi?id=735861
gst_zebra_stripe_transform_frame_ip_planarY
gst_zebra_stripe_transform_frame_ip_YUY2
gst_zebra_stripe_transform_frame_ip_AYUV
all above 3 functions do the same functionality except for offset and pixel stride.
Hence moving the functionality to a single funtion.
https://bugzilla.gnome.org/show_bug.cgi?id=735032
Do more elaborate validation of the input caps: what fields
are required and/or not allowed. Don't assume AVC3 format
input without codec_data field is byte-stream format. Fix
up some now-unreachable code (CID 1232800).
It should try to use bytestream in these cases that the format
is set to _FORMAT_NONE as it seems that is what the 'else' clause
for bytestream can handle (by defaulting to _FORMAT_BYTESTREAM).
gst_pad_get_pad_template_caps() returns a reference which is unreferenced,
so creating a copy using gst_caps_copy() results in a reference leak.
Fixes https://bugzilla.gnome.org/show_bug.cgi?id=734528
32 bit integers are going to overflow, especially the PCR offset to
the first PCR will overflow after about 159 seconds. This makes playback
of streams stop at 159 seconds as suddenly the timestamps are starting
again from 0. Now we have a few more years time until it happens again
and 64 bits are too small.
