When seeking back to original state after duration seeks, let
upstream know that we want the whole file, including the last
byte that wasn't requested on the duration seeks.
https://bugzilla.gnome.org/show_bug.cgi?id=724633
A change in gst_ogg_demux_do_seek caused oggdemux to wait for
a page for each of the streams, including a skeleton stream if
one was present. Since Skeleton only has header pages, that
was never going to end well.
Also, the code was skipping CMML streams when looking for pages,
so would also have broken on CMML streams.
Thus, we change the code to disregard Skeleton streams, as well
as discontinuous streams (such as CMML and Kate). While it may
be desirable to consider Kate streams too (in order to avoid
losing a subtitle starting near the seek point), this may be
a performance drag when seeking where no subtitles are. Maybe
one could add a "give up" threshold for such discontinuous
streams, so we'd get any page if there is one, but do not end
up reading preposterous amounts of data otherwise.
In any case, it is important that the code that determines
the amount of streams to look pages for remains consistent with
the "early out" conditions of the code that actually parses
the incoming pages, lest we never decrease the pending counter
to zero.
This fixes seeking on a file with a skeleton track reading all
the file on each seek.
https://bugzilla.gnome.org/show_bug.cgi?id=719615
Ogg data is read chunk by chunk, and the chunk size used was
originally taken from libvorbisfile. However, this value leads
to poor performance when used on an Ogg file with large pages
(Ogg pages can be close to 64 KB).
We can't just use a larger chunk size, since this will decrease
performance on small page streams, so we use an adaptive scheme
where the chunk size is twice the largest page size we've seen
so far in the stream. For "typical" Ogg/Vorbis, this gives us
almost the same chunk size (a bit lower), and this lets us get
better performance on streams with large pages.
Store the seek stop and seqnum and properly restore them when
receiving the corresponding Segment from upstream. Also fixes
seqnum for converted seek events.
When bisecting after an earliest time has been found, we need
to only consider the stream for which the earliest time was found.
Before, the following scenario could be and was encountered:
a) Find the earliest time for stream X
b) bisect and find a page which granuletime is indeed < target, but
contains another stream.
c) decide to seek at the wrong offset, sometimes inferior to
the real one, in which case the error was undected or
d) the offset was superior, and thus the actual target keyframe was
not processed, and packets were skipped waiting
for a granulepos.
https://bugzilla.gnome.org/show_bug.cgi?id=700537
If our previous flow return was NOT_LINKED, don't try to push on the pads some
more. If we get a RECONFIGURE event on the pad, try to push on it again.
Changed the check to a current_time equal to the stop will produce
EOS instead of the next one. Also, segment.start can't be NONE, so removing
this check.
Fixes https://bugzilla.gnome.org/show_bug.cgi?id=696899
No need to copy buffers we put into the streamheader any more
now that we don't put caps on buffers any more, so there's no
danger of a refcount cycle.
A crafted file with invalid pages will cause repeated searches from
earlier offsets in steps of 8500 bytes, but reading till the end of
the stream. Since we know the maximum size of an Ogg page, we can
bound the search for next page, to get a linear behavior (though
still not good enough as it will read the entire file backwards if
there's no valid page till then).
Take chain lock when accessing chains. Fall back gracefully
when there's no current chain Hopefully fixes crash when
seeking in Jamendo or Magnatune streams in Amarok.
https://bugzilla.gnome.org/show_bug.cgi?id=675609
They're hardly used, and probably more confusing than anything
else, and it's not clear that anyone would really need to be
able to tell them apart at the media type level.
This never really took off - it's hardly used anywhere
and deprecated in favour of Kate. Exposing pads just
leads to confusing 'you are missing a plug-in' messages
when people come across such streams. We could still post
the data on the bus for applications to parse.
