After we reset the resampler, there is no history anymore in the resampler
and the previously calculated output size is no longer valid.
Recalculate the new output size after a reset to make sure we don't try
to convert too much.
Remove some unused variables from the inner product functions.
Make filter coefficients by interpolating if required.
Rename some fields.
Try hard to not recalculate filters when just chaging the rate.
Add more proprties to audioresample.
Remove the consumed/produced output fields from the resampler and
converter. Let the caler specify the right number of input/output
samples so we can be more optimal.
Use just one function to update the converter configuration.
Simplify some things internally.
Make it possible to use writable input as temp space in audioconvert.
Avoid overflow in rate calculation. This can cause the resampler to
start on the wrong phase after a rate change.
Avoid overflow in cubic fraction calculation. This can cause noise when
dealing with higher samplerates.
Speex may decide not to consume any samples because it can't write any. I've
seen a hang during draining caused by the resample loop never terminating.
In that case, resampling happened as normal until olen was 0 but ilen was
still 1. _process_native then reduced ichunk to 0, so ilen never decreased
below 1 and the loop never terminated.
Instead of reverting 684cf44 ({audioresample: don't skip input samples),
break only if all output samples have been produced and speex refuses
to consume any more input samples.
https://bugzilla.gnome.org/show_bug.cgi?id=732908
when downsampling, the output buffer can be filled before all the input
samples are consumed. this is correct: when downsampling, several input
samples are needed for each output sample, so when only a small number of
input samples are available the number of output samples produced can be 0.
the resampler, however, was discarding those extra input samples instead of
clocking them into its filter history for the next iteration. this patch
fixes this by removing the check that the output buffer is full. the code
now always loops until all input samples are consumed, and relies on the
calling code to have provided a suitably sized location for the output.
note that there are already other checks in place in the calling code to
ensure that this is the case.
https://bugzilla.gnome.org/show_bug.cgi?id=732908
This is an adaptation of patch #3 from Jyri Sarha
( http://lists.xiph.org/pipermail/speex-dev/2011-September/008240.html ),
but without the NEON optimizations (these come in a separate commit).
The idea is to replace SATURATE32(PSHR32(x, shift), a) operations with a
combined SATURATE32PSHR(x, shift, a) macro that can be optimized for
specific platforms (and also avoids rare rounding errors).
Signed-off-by: Carlos Rafael Giani <dv@pseudoterminal.org>
../../../gst-plugins-base/gst/audioresample/gstaudioresample.c: In function 'gst_audio_resample_dump_drain':
../../../gst-plugins-base/gst/audioresample/gstaudioresample.c:729:9: warning: variable 'in_len' set but not used [-Wunused-but-set-variable]
