In a fragmented scenario, qtdemux is operating in push mode
and it gets a fragmented buffer. While processing its data
downstream gets unlinked (or a input-selector changes its
active pad and returns not-linked). Qtdemux stops processing
this fragment and returns not-linked upstream, leaving the
remaining data in its adapter.
When it gets an EOS it should make sure that all the data it
had received is pushed before pushing EOS.
libshout2 (we require > 2.0 at config time) supports
both IP and hostname for _set_host(). Dropped an
outdated FIXME regarding this limitation, adjusted
some comments and changed the param blurb to reflect
this too.
According to RFC 5104 section 4.3.1.2, RTCP PSFB FIR message SHALL
have a media_ssrc field set to 0. The actual media ssrc is in the FCI.
So in that case, we ignore the retained feedback and just let it through
to the rtp_session_process_fir() function which will check for the actual
SSRC inside the FCI.
Fixes a regression introduced by commit 57c27ec3
Previously, when the session had multiple internal sender SSRCs, it would
issue SR reports with RB blocks only on the first RTCP timeout and afterwards
SR reports would be sent empty. This was because the "generation" number
in RTPSource would increase more than once during the same cycle and afterwards
it would always be greater than the session's generation, which would cause
it to be skipped from being included in RBs.
This commit fixes this problem by:
1) Increasing the RTPSource generation only at the end of each cycle,
which essentially fixes the problem but only when the internal senders
are less than GST_RTCP_MAX_RB_COUNT.
2) Keeping for each RTPSource a set of SSRCs which stores which SSRC's
SR the given RTPSource has been reported in, which also fixes the problem
when the internal senders are more than GST_RTCP_MAX_RB_COUNT. This is
necessary because of the fact that any RTPSource is marked as reported
in itself's SR and makes it impossible to know if it has been reported
in other SRs too or not, and which.
This test checks that when we have multiple internal sender sources
in rtpsession, SRs contain RBs for every other sender source, and that
they are included roundrobin when they exceed ST_RTCP_MAX_RB_COUNT,
which is the max number of RBs that can fit in a SR.
Keep an extra stats structure for scheduling the BYE packets. When we
decide to schedule BYE, make a copy of the current stats into the
bye_stats. Then while we schedule the BYE, update and use only the
bye_stats. When we finished scheduling the BYE packet, we use the
regular stats again.
When we are scheduling BYE packets, ignore all RTCP for the sources that
are scheduling a BYE packet. Other sources that are not scheduling BYE
should continue receiving RTCP packets as usual.
