In some cases, it is possible that we need to update the manifest before
pads have been exposed at all. If there are no current pads, just expose
the next prepared streams. This doesn't handle the case where a manifest
update would happen while a live streams is changing periods, which is a
type of use case that we're unaware of real usages yet.
https://bugzilla.gnome.org/show_bug.cgi?id=783028
This is wrong because:
* If the rate is negative we should check for the *previous* period
* adaptivedemux already does the proper checks before calling this
method
This ensures smoother playback. It looks weird if we first do a big
jump, then play a couple of consecutive frames, just to again skip ahead
quite a bit because we ran late again.
Far enough here means more than 500ms or 4 times the average keyframe
download time. There is no need to jump ahead by one average keyframe
download time in this case.
This makes playback smooth if the network is fast enough.
When dealing with key-unit trick mode downloads, the goal is to
provide the best "Quality of Experience". This is achieved by:
1) maximizing the number of frames displayed per second
2) avoiding "stalling" as much as possible (i.e. not downloading and
decoding frames fast enough)
This implementation achives this by:
1) Knowing very precisely the current keyframe being download (i.e
more accurate than at the fragment level which might contain more
than one keyfram). This is the new "actual_position" variable
introduced by this commit
2) Knowing the position of downstream (provided by QoS and stored
in the adaptivedemuxstream qos_earliest_time variable)
3) Knowing how long it takes to request and fully download a keyframe
(the average_download_time variable)
Taking those 3 variables into account, whenever a keyframe has been
pushed downstream we calculate a "target time" (target_time variable)
which is the ideal next keyframe time to request so that:
1) It will be requested/downloaded/demuxed/decoded in time to be
displayed without being too late
2) It will not be too far ahead that it would cause too few frames
per second to be displayed.
How far ahead we will request is inversily proportional to how close
the actual position (actual_position) is from the downstream
position (qos_earliest_time). The more is buffered between the source
and the sink, the "closer" the target time will be, and therefore
the more frames per seconds will be displayed (up to the limit
of keyframes_per_second * absolute_rate).
If a manifest has non-zero presentation time offset
(i.e., earliest presentation time specified by sidx box is not zero),
the initial sidx position shouldn't be zero. Since we cannot define
exact sidx position until parsing sidx box, set the value to unknown.
https://bugzilla.gnome.org/show_bug.cgi?id=782693
The previous code was handling both as separate steps and then tried to
combine the results, but this resulted in all kinds of bugs which showed
themselves as failures during seeking and offset tracking getting wrong.
This also showed itself with gst-validate on the sample stream.
The rewritten code now parses everything in one go and tracks the
current offset only once, and as a side effect simplifies the code a
lot.
Also added is detection of SIDX that point to other SIDX instead of
actual media segments, e.g. with this stream:
http://dash.akamaized.net/dash264/TestCases/1a/sony/SNE_DASH_SD_CASE1A_REVISED.mpd
Support for this will have to be added at some point but that should
also be easier with the rewritten code.
https://bugzilla.gnome.org/show_bug.cgi?id=781233
Spec 5.3.9.2 is saying about the existence of duration and SegmentTimeline
only for Representation level. Other level such as Period or AdaptationSet
might not have the attributes.
https://bugzilla.gnome.org/show_bug.cgi?id=780570
This reverts commit c9fbf3459a.
The representation ID comparision here was wrong and triggering always
if the ID did *not* change, causing needless redownloading of the
header. The sample stream provided in the bug does not exist anymore.
Otherwise we'll get into an infinite loop here. Now this is still not
correct and will cause a clean error, but at least it won't hang forever
anymore.
For each period, media presentation is the relative to the
period-start time. So SIDX seek position should be target seek
position minus period-start. Also, if presentationTimeOffset
is defined, the value should be compensated
https://bugzilla.gnome.org/show_bug.cgi?id=780397
