This reverts the decision from
https://bugzilla.gnome.org/show_bug.cgi?id=754230
where it was decided that we rather play safe and only use the `tfdt` if
it is "significantly different" to the sum of sample durations.
As the specification says
If the time expressed in the track fragment decode time (‘tfdt’) box
exceeds the sum of the durations of the samples in the preceding
movie and movie fragments, then the duration of the last sample
preceding this track fragment is extended such that the sum now
equals the time given in this box.
we have to use the `tfdt` in general to allow for it to signal gaps in
the stream.
A muxer producing fragments might not yet know the full duration of the
last sample of a previous fragment if the next fragment starts with a
gap, and knowing the actual start of the next fragment would potentially
require to violate latency requirements.
Additionally, the existence of `tfdt` allows to avoid accumulating
rounding errors from summing up the durations.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3586>
The rtpjitterbuffer test drop_messages_interval uses a GstClockTime for
the message drop interval. This property is defined as a guint. On
systems with 64-bit time_t but 32-bit uint, this can cause the
g_object_set function to fail to read the arguments properly.
Fixes: #1656
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3580>
If we keep the old events they can be end up being passed to the app, that could
discard the protection information because it has been seen before.
Drive by improvement: use g_queue_clear_full instead of foreach+clear for
protection events.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3547>
jpegdec is capable to parse input frames, but if jpegparse is before,
there's no need to reparse frames. This patch configure jpegdec as
packetized, skipping parsing, if negotiated sink caps has the boolean
field 'parsed' as true.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/2464>
According to comment in gst_pulsering_stream_latency_cb, latency updates
happen every 100 ms. The code in gst_pulsering_stream_latency_cb does
not care about the actual state of the ringbuffer, pbuf->acquired or
not.
Thus, every 100 ms the ringbuf->segdone may be set, even though the
object itself might be in 'destroyed' state. On next
gst_pulseringbuffer_acquire the segdone is not touched, so playback may
resume with invalid/wrong segdone value. This finally leads to a period
of silence playing after resuming the pipeline.
The problem was found on 'not-yet-released'-hardware and so far was not
reproducible on desktop computer.
Removing the callback as long as the ringbuffer is not in 'acquired'
state solves the problem reliably on the hardware device that the issue
was detected on.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3082>
The stream selection is done on the currently outputting tracks, but in order to
(de)activate the backing streams we can only do it if the input and output
period are identical.
Fixes crash when doing stream selection during period migration
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3525>
This regression was introduce by fix for making buffer pool thread safe. When
we renegotiate, the pool will be setup after we set the format. But the code
has been simplified to only get the pool once before, which caused a null
pointer deref.
Fixes 94ba019 ("v4l2: Fix SIGSEGV on 'change state' during 'format change'")
Related to !3481Fixes#1626
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3513>
Currently in rtp_session_send_rtp(), the existing ntp-64 RTP header
extension timestamp is updated with the actual NTP time before sending
the packet. However, there are some circumstances where we would like
to preserve the original timestamp obtained from reference timestamp
buffer metadata.
This commit provides the ability to configure whether or not to update
the ntp-64 header extension timestamp with the actual NTP time via the
update-ntp64-header-ext boolean property. The property is also exposed
via rtpbin. Default property value of TRUE will preserve existing
behavior (update ntp-64 header ext with actual NTP time).
Fixes https://gitlab.freedesktop.org/gstreamer/gstreamer/-/issues/1580
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3451>
- Based heavily on the existing Qt5 integration however:
- The sharing of OpenGL resources is slightly different
- The integration with the scengraph is a bit different
- Wayland, XCB and KMS have been smoke tested. Android, MacOS/iOS,
Windows may or may not work.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3281>
Previously we tried to route an incoming RTCP FB FIR to the correct ssrc
using the "media source" component of the RTCP FB message. However,
according to RFC5104 (section 4.3.1.2) the "media source" SHALL be set
to 0. Instead the ssrc(s) in use are propagated via the FCI data. Now
a specific GstForceKeyUnit event is sent for every ssrc.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3292>
RTP source statistics are tracked for local senders by
treating them as a receiver of their own outbound packets.
Accordingly, track the highest packet seqnum so that the
packets-lost calculation generates a sensible number instead
of always reporting -$number_of_packets_sent
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3454>
When getting a "404 Not Found" response from the DESCRIBE request, the
source produced a "No supported authentication protocol was found" error
instead of passing on the 404, which was confusing.
Only produce this error message when we're handling a response of "401
Unauthorized" without a compatible WWW-Authenticate header.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3414>
In current tile representation, only tiles with power of two
width and height in bytes are supported. This limitation
prevents adding more complex tiles formats.
In this patch, we deprecate tile_ws and tile_hs from GstVideoFormatInfo and
replace if with an array of GstVideoTileInfo. Each plane tiles are then
described with their pixels width/height, line stride and total size.
The helper gst_video_format_info_get_tile_sizes() that depends on the
deprecated API is also being removed. This can simply be removed as it wasn't
in any stable release yet.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3424>
The only case where we definitely need to write a new trun is when the
data_offset value does not match the end of the list of entries.
Needing multiple trun atoms is required when interleaving multiple
streams together.
All other cases can be covered by adding more entries to the existing
trun atom.
Fixes playback of fragemented mp4 in ffplay and chrome.
Using e.g. mp4mux fragment-duration=1000 fragment-mode=dash-or-mss
and
mp4mux fragment-duration=1000 fragment-mode=first-moov-then-finalise
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3426>
Postpone the cleanup of any consecutive sequence of lost frames
which starts at frame 0, until frame 100 is dequeued from driver.
This allows fluster tests JVT/CVWP2_TOSHIBA_E, JVC/CVWP3_TOSHIBA_E
and HEVC/POC_A_Bossen_3 that sends out-of-order frames to successfully
complete (e.g., test of Amphion vpu driver).
Fixes#1569
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3398>
In order to figure out if the "raw" audio contained within the wav
container is actually DTS, wavparse calls the typefinder helper
except that means it runs all typefinders.
Since it only cares about checking for DTS, we should only run the
audio/x-dts typefinder (if present). Commit 858e516 did not really
fix things.
Use the new type helper with the caps to fix this.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3417>
Set udpsrc seqnums on all events sent to the udpsrc's, and before
forwarding events out of rtspsrc set the latest seek seqnum on them if
any.
Also produce a consistent seqnum in rtspsrc from the very beginning.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gstreamer/-/merge_requests/3409>
