gstreamer/autogen.sh

#!/bin/sh
which autoreconf > /dev/null
if [ $? -ne 0 ] ; then
       echo "Please install autoconf" && exit 1;
fi
which libtool > /dev/null 2>&1
if [ $? -ne 0 ] ; then
       echo "Please install libtool" && exit 1;
fi

mkdir -p m4
autoreconf  -i --force --warnings=none -I . -I m4 && \
./configure --enable-maintainer-mode $*
Initial commit 2013-06-17 14:23:54 +00:00			`#!/bin/sh`
autogen.sh: advice about installing autoconf if autoreconf not found 2014-03-31 15:46:02 +00:00			`which autoreconf > /dev/null`
			`if [ $? -ne 0 ] ; then`
			`echo "Please install autoconf" && exit 1;`
			`fi`
autogen.sh: advice about installing libtool libtool not being present in a system meant that this cryptic error about LT_INIT would be shown: sources/glue/Makefile.am:1: error: Libtool library used but 'LIBTOOL' is undefined sources/glue/Makefile.am:1: The usual way to define 'LIBTOOL' is to add 'LT_INIT' sources/glue/Makefile.am:1: to 'configure.ac' and run 'aclocal' and 'autoconf' again. sources/glue/Makefile.am:1: If 'LT_INIT' is in 'configure.ac', make sure sources/glue/Makefile.am:1: its definition is in aclocal's search path. autoreconf: automake failed with exit status: 1 2014-03-31 20:16:47 +00:00			`which libtool > /dev/null 2>&1`
			`if [ $? -ne 0 ] ; then`
			`echo "Please install libtool" && exit 1;`
			`fi`

Initial commit 2013-06-17 14:23:54 +00:00			`mkdir -p m4`
autogen.sh: don't run ./configure if autoreconf failed The following line could be seen in the middle of the log: autoreconf: automake failed with exit status: 1 Clearly the configuration phase should not continue from there. 2014-03-31 16:02:09 +00:00			`autoreconf -i --force --warnings=none -I . -I m4 && \`
Initial commit 2013-06-17 14:23:54 +00:00			`./configure --enable-maintainer-mode $*`