New signals are added for managing the internal list of rtp header
extension implementations read by a specific depayloader instance.
If the 'extmap-$NUM' field is present in the src caps, then an
extension implementation will be requested but is not required to be able
to negotiate correctly. An extension will be requested using the
'request-extension' signal if none could be found internally.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gst-plugins-base/-/merge_requests/748>
New signals are added for managing the internal list of rtp header
extension implementations read by a specific depayloader instance.
If the 'extmap-$NUM' field is present in the sink caps, then an
extension implementation will be requested but is not requited to be
able to negotiate correctly. An extension will be requested using the
'request-extension' signal if none could be found internally.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gst-plugins-base/-/merge_requests/748>
We validate the header extensions length of an RTP buffer by comparing
it against the block size. Since we multiply the length in words by 4 to
get the length in bytes, a suitably large length could cause a wrapround
of the uint16, giving a lower length which erroneously passes the check
and allows the buffer to be mapped.
Part-of: <https://gitlab.freedesktop.org/gstreamer/gst-plugins-base/-/merge_requests/864>
The wordlen ("length") MUST represent the total "number of 32-bit words
in the extension, excluding the four-octet extension header" (rfc3550).
There are cases where already existent padding is reused for adding
the new extension. So the new wordlen should be updated if the new
added extension makes it to increase.
This patch introduces a property which, if set to FALSE, prevents RTP
basepayloader from scaling the RTP time when a segment's rate is not
equal to 1.0. The specification is ambiguous on this subject and some
clients expect the timestamps not to be scaled.
By setting the extension-ID for TWCC (Transport Wide Congestion Control),
the payloader will embed sequencenumbers as a RTP header-extension
according to https://tools.ietf.org/html/draft-holmer-rmcat-transport-wide-cc-extensions-01#section-2
The negotiation of this being enabled with downstream elements
is done with caps reflecting the way this is communicated using SDP.
With commit "basepayload: Expose onvif-no-rate-control property" the rtp
timestamp changed behaviour when rate control is disabled.
When disabling rate control, we must take care of the stream time to
avoid the timestamps to begin from zero again.
Save push/push_list helper flow return and in case of failure, return it
in the process function. This allow forwarding downstream flow return
even if the subclass is using the push/push_list helper.
basedepayload generates its own segment in a pretty unconventional
manner, relying on information in the caps such as npt-start or
npt-stop, usually set by rtspsrc.
In ONVIF mode, rtspsrc will generate the correct segment and this
logic in rtpbasedepayload will not be needed, this commit allows
rtspsrc to signal that through the caps.
Add max-reorder property to make the old hard coded reordering limit of
100 configurable. It's particularly useful in some scenarios to set
max-reorder=0 to disable the behavior that the depayloader will drop
packets.
Note that although the default value is 100, the default limit has
increased with one because of the changed if-test. This was done to
allow the max-reorder value to be more intuitive. See tests.
Since we started depending on GLib 2.44, we can be sure this macro is
defined (it will be a no-op on compilers that don't support it). For
plugins we should just start using `G_DECLARE_FINAL_TYPE` which means we
no longer need the macro there, but for most types in base/gst-libs we
don't want to break ABI, which means it's better to just keep it like it
is (and use the `#ifdef` instead).
The function rtcp_packet_min_length() returns a length for each known type
and -1 for unknown types. This change fixes the test accordingly and silences
the following warning.
gstrtcpbuffer.c:567:12: error: comparison of constant -1 with expression of type 'GstRTCPType' is always false
[-Werror,-Wtautological-constant-out-of-range-compare]
if (type == -1)
Before a gap event is pushed downstream a segment event must be pushed
since the gap event can cause packet concealment downstream and hence
data flow. Since concealment before receiving any data packets usually
doesn't make any sense, the gap event is not sent downstream.
Alternatively one could generate a default caps and segment event, but
no need to complicate things until it's proven necessary.
https://bugzilla.gnome.org/show_bug.cgi?id=773104https://gitlab.freedesktop.org/gstreamer/gst-plugins-base/issues/301
Checking the address distance between given begin/end sequence
doesn't make sense. They are output params.
This is to fix weird failure of libs_rtp on Windows
Code in g_return_*() must not have side effects, as it
might be compiled out if -DG_DISABLE_CHECKS is used, in
which case we would read garbage off the stack.
According to RFC3611, the extended report blocks in XR packet can
have variable length. To visit each block, the iterator should look
into block header. Once XR type is extracted, users can parse the
detailed information by given functions.
Loss/Duplicate RLE
The Loss RLE and the Duplicate RLE have same format so
they can share parsers. For unit test, randomly generated
pseudo packet is used.
Packet Receipt Times
The packet receipt times report block has a list of receipt
times which are in [begin_seq, end_seq).
Receiver Reference Time paser for XR packet
The receiver reference time has ntptime which is 64 bit type.
DLRR
The DLRR report block consists of sub-blocks which has ssrc, last RR,
and delay since last RR. The number of sub-blocks should be calculated
from block length.
Statistics Summary
The Statistics Summary report block provides fixed length
information.
VoIP Metrics
VoIP Metrics consists of several metrics even though they are in
a report block. Data retrieving functions are added per metrics.
https://bugzilla.gnome.org/show_bug.cgi?id=789822
