In push mode, we determine duration by doing a seek to the end of the
stream. However, a skeleton stream with an index will cause the duration
to be known already, and we end up never setting the push_time_duration
variable which we use to know duration has been determined.
https://bugzilla.gnome.org/show_bug.cgi?id=662049
The codec setup headers are a lot more likely to have correct information,
especially as it's easy to remux a skeleton in a file where streams don't
have the same parameters (I've even seen a file with two skeletons).
Still, this is useful in the case we have a codec we can't decode, so we
can at least (theoretically) convert granpos to time, so we discard this
information if the codec setup has already provided it.
This fixes playback on (at lesat) the original archive.org encoding of
"The Night of the Living Dead" (now replaced by another encoding).
https://bugzilla.gnome.org/show_bug.cgi?id=612443
This could happen when testing with navseek, and pressing
right and left at roughly the same time. The current chain
is temporarily moved away, and this caused the flush events
not to be sent to the source pads, which would cause the
data queues downstream to reject incoming data after the
seek, and shut down, wedging the pipeline.
Now, I can't really decide whether this is a nasty steaming
hack or a good fix, but it certainly does fix the issue, and
does not seem to break anything else so far.
https://bugzilla.gnome.org/show_bug.cgi?id=621897
This patch implements seeking in push mode (eg, over the net)
in Ogg, using the double bisection method.
As a side effect, it also fixes duration determination of network
streams, by seeking to the end to check the actual duration.
Known issues:
- Getting an EOS while seeking stops the streaming task, I can't
find a way to prevent this (eg, by issuing a seek in the event
handler).
- Seeking twice in a VERY short succession with playbin2 fails
for streams with subtitles, we end up pushing in a dataqueue
which is flushing. Rare in normal use AFAICT.
- Seeking is slow on slow links - byte ranges guesses could be
made better, decreasing the number of required requests
- If no granule position is found in the last 64 KB of a stream,
duration will be left unknown (should be pretty rare)
https://bugzilla.gnome.org/show_bug.cgi?id=621897
The first packet of a sparse stream may arrive after an initial
delay in the stream. If ogg_stream_packetout reports a discontinuity
in a sparse stream, do not propagate it to other streams in the
chain unnecessarily.
https://bugzilla.gnome.org/show_bug.cgi?id=621897
After all, we do hope to find actual data for these streams.
However, warn if we could not set up a chain when we find a
non BOS page, as that means we don't have a valid Ogg stream.
https://bugzilla.gnome.org/show_bug.cgi?id=657151
While the casual reader might end up bewildered by just why this
change might increase clarity, it just happens than, in the libogg
and associated sources, op is the canonical name for an ogg_packet
whlie og is the canonical name for an ogg_page, and reading this
code confuses me.
https://bugzilla.gnome.org/show_bug.cgi?id=657151
Headers are inherently durationless.
Instead, set duration to 0 to avoid increasing tracked granpos,
and do not warn about it, since it is totally expected.
https://bugzilla.gnome.org/show_bug.cgi?id=657151
If ints are 64 bits, 32 bits should get promoted in varargs anyway,
and we don't care about 16 bit ints.
This makes the code a lot more readable, and still gets us nice
hexadecimal 32 bit serialnos.
https://bugzilla.gnome.org/show_bug.cgi?id=656775
This was causing keyframe_granule to be set to 0 for all streams
when seeking to the beginning of the stream, i.e., at the
beginning of playback. Fixes#619778.
allocate buffers using gst_buffer_new_and_alloc() instead of
gst_pad_alloc_buffer_and_set_caps(), as the first one will
cause the pad to block, and we don't want that since that will
prevent subsequent pads from being fed if a block occurs at
start, when all pads must be fed for playback to start.
This fixes autoplugging of the tiger element and other things.
https://bugzilla.gnome.org/show_bug.cgi?id=637822
Oggdemux will currently try to pad alloc a buffer from the peer when it is
reading the header files. This is a relic from the time where we had an internal
parser and needs to be removed at some point in time.
The problem is that when there is no peer pad yet (which is normal when
collecting headers) we should still continue to parse all the packets of a
page instead of erroring out on NOT_LINKED.
Fixes#632167
Only keep the last valid granulepos we see when scanning the last
pages. It is possible that the last page that we inspect has a -1 granulepos, in
which case we want to keep the previous valid time instead.
Fixes#631703
Files with a skeleton, or other files with a stream that ends before the end of
the chain would start playing from the end of the chain when trying to seek with
a negative rate at a position between the end of any stream and the end of the
chain.
This is due to the loop in _do_seek() assuming that pages will be encountered
for all streams shortly after the place where we want to seek, as found by
do_binary_search().
In the first iteration of the loop, stream ends are now checked against the
time of the current page.
