From d9351bf4d336b0c2c8fb52b14e4598f55783c088 Mon Sep 17 00:00:00 2001 From: Lotte Steenbrink Date: Fri, 24 Jul 2020 10:00:38 +0200 Subject: [PATCH] hardware.md: driveby: add note on how to orient the board --- embedded-workshop-book/src/hardware.md | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/embedded-workshop-book/src/hardware.md b/embedded-workshop-book/src/hardware.md index 07401f2..28329f5 100644 --- a/embedded-workshop-book/src/hardware.md +++ b/embedded-workshop-book/src/hardware.md @@ -106,7 +106,7 @@ $ ls /dev/tty.usbmodem* /dev/tty.usbmodem0006834208031 ``` -The board has several switches to configure its behavior. The out of the box configuration is the one we want. If the above instructions didn't work for you, check the position of the on-board switches: +The board has several switches to configure its behavior. The out of the box configuration is the one we want. If the above instructions didn't work for you, position the board so that the Button descriptions are horizontal and check the position of the on-board switches: - Switch SW6, on the top edge right corner, is set to the DEFAULT position; this is the right position of the two possible positions (nRF = DEFAULT). Note that this switch is protected by Kapton tape. - Switch SW7, which is slightly up and to the right of the center of the board, is set to the Def. position; this is the right position of the two possible positions (TRACE = Def.)